← Back to contents

ASCII text — 1K bytes — PP20 compressed


    This programme was written on an A500 with 1Meg and a hard drive. It works
    on my machine with no known bugs. If you are running it on some other 
    system and you have problems please let me know. This file details known
    problems on some other systems together with possible fixes. It also
    contains some general information about running AMOS programmes.

     This programme was programmed by Andrew Kreibich with AMOSv1.35
     (C) 1990 Mandarin/Jawx (Europress) and compiled with the AMOS compiler.
     It should run on any amiga including 1200.
 
     Note: to quit at any time (without using the menu) press Ctrl-C.
           to toggle workbench use left Amiga-A (Amiga N and M will not work)  


    NOTE OLD A1000 USERS. 
    @@@@@@@@@@@@@@@@@@@@
  
    I have heard a number of reports that AMOS has problems with old A1000s. 
    If the programme gurus, locks up your machine, loses the mouse pointer 
    or anything else unusual then try it on another machine. I have no way 
    of fixing it to work on old A1000s.




                         IMPORTANT!!!

    This programme assumes that the system font is topaz 8.
    If any of the text is too big for the buttons this is because
    you have changed the system font.
    If this causes you problems then I can send you a version which 
    will set the font for you. (Only available when you register, please
    let me know if you want it)

    

    
     MOUSE PROBLEMS?

     Some users have reported a disappearing mouse pointer when running 
     DMouse at the same time. If this happens to you and you are running
     Dmouse or any other sort of fancy mouse accessory then turn it off and
     try again.

     If you are running on a faster system (eg you are lucky enough to afford
     an accelerator card) then you might have a few problems with timing. This
     could manifest itself by refusing to accept the mouse click until you
     have hit it a few times. Annoying, I know, but I have tried to prevent 
     this with carefully structured loops etc. but unfortunately I have no
     way of testing it! (as I said above it works fine on my machine). I have
     two solutions to this.
      
       1. turn off the accelerator (if possible)

       2. register and persaude a few hundred others to do likewise so 
          that I can afford an accelerator and test it out myself!



   


    Now read the doc. file!